Buyers value an owner-run electrical company at a multiple of its seller discretionary earnings (SDE), then adjust for how steady the work is and who holds the license. SDE is your yearly profit plus what you pay yourself. Service work, maintenance contracts and licensed electricians who stay raise the multiple. A license that rests on the owner and work that comes from a few general contractors lower it. Most electrical and mechanical contractors sold from 2021 to 2025 went for 1.96x to 3.15x SDE, going by BizBuySell’s records [6]. For a range based on your numbers, run the free electrical valuation.

Two kinds of electrical company

Most small electrical contractors are a mix of two businesses. Buyers value them very differently.

The service business. Repair calls, panel upgrades, generator and EV charger installs, lighting retrofits and maintenance for stores, plants and property managers. Jobs are small and frequent. Customers call back. A buyer can see next year’s work in last year’s customer list.

The bid business. Wiring new homes, offices and tenant build-outs for general contractors. Jobs are big and come one at a time. The work depends on winning the next bid and on a few general contractors. Cash is often tied up in retainage, money the contractor holds back until the job is done.

Neither is bad. But a dollar of profit from service work usually earns a higher multiple than a dollar from bid work. Split three years of revenue and gross margin (sales minus direct job costs) between the two. If you can, split service further into calls, upgrades and maintenance contracts.

Rebuild your earnings as SDE

Buyers rebuild your profit as SDE: pre-tax profit, plus one owner’s pay and benefits, plus equipment write-downs (depreciation), interest and documented one-time or personal costs. Our guide to SDE and add-backs explains each line, and the SDE calculator does the math.

Add-backs (costs a new owner would not have) worth checking in an electrical company:

  • Depreciation on vans, bucket trucks and lifts. It comes back. Buyers will still ask what you spend each year to replace them.
  • Owner’s vehicle and phone, if mainly personal.
  • One-time costs, such as a lost lawsuit or a software switch, with proof.

Electrical has one item that cuts the other way. Job profit can be timed. On bid jobs, profit shows up when you bill, not when you earn it. A buyer may look at percent-complete reports to see if last year’s profit was pulled forward or pushed back. Clean job costing makes that check quick.

The master electrician question

In most states, the right to do electrical contracting rests on a licensed person. The Bureau of Labor Statistics notes that most states require electricians to be licensed, and requirements vary by state [2].

Texas makes the risk easy to see. To hold an electrical contractor license, a company must employ a licensed master electrician. The master may be the owner. A master can be assigned to only one contractor, unless they own more than 50% of it. When the master of record leaves, the company must name a new one within 30 business days [1].

For a buyer, that means:

  • If you are the only master, the buyer must find one before or soon after closing. Masters are not easy to hire.
  • A master who works for another contractor cannot simply switch to yours on paper.
  • A second master on your staff, who agrees to stay, removes the biggest single risk in the deal.

Texas also requires electrical contractors to carry at least $300,000 per occurrence and $600,000 in total liability insurance, plus $300,000 for completed work, and to show proof of workers’ compensation or a similar option [1]. The buyer’s company will need its own coverage on day one. Our guide on selling when you hold the license covers the options.

What the published data says

BizBuySell, a site where owners list businesses for sale, reports what contractors sold for. Its category is wider than ours. It mixes electrical with mechanical contractors. Across 266 of those sales from 2021 to 2025, the middle half went for 1.96x to 3.15x SDE. In plain terms, one in four sold for less than 1.96x and one in four for more than 3.15x. The middle sale was 2.56x [6]. Our sale price data page lists these numbers next to the other trades.

The Market Pulse survey by the International Business Brokers Association (IBBA) and M&A Source covers all industries. Here is what it reported for Q2 2026 [3]:

Deal size (purchase price) Multiple, Q2 2026
Under $500,000 2.0x SDE
$500,000 to $1 million 2.8x SDE
$1 million to $2 million 3.1x SDE
$2 million to $5 million 4.0x EBITDA

Bigger contractors with a management team are priced on EBITDA (profit before interest, taxes and write-downs, after paying a manager). That base is smaller than SDE, so the multiple looks bigger. Do not mix the two.

A worked example

The figures below are illustrative. They describe no real company. This is an electrical contractor with one owner who is the master electrician, 14 electricians and two office staff.

Line Amount
Revenue (45% service and maintenance, 55% bid work) $3,100,000
Pre-tax net profit $214,000
Add back: owner salary and payroll taxes $135,000
Add back: owner health insurance $18,000
Add back: depreciation on vans and a bucket truck $52,000
Add back: interest on equipment loans $9,000
Add back: one-time legal settlement $22,000
SDE $450,000
At 1.96x (low end of the middle half) $882,000
At 3.15x (high end of the middle half) $1,417,500

Where would this company land? Look at the license and the mix.

  • Toward the top if a second master on staff will stay, the service share has grown each year and no general contractor brings more than a fifth of revenue.
  • Toward the bottom if the owner is the only master, two general contractors bring most of the bid work and the backlog is thin.

This company would sell for somewhere between $882,000 and $1,417,500. For deals that size, the IBBA reported 2.8x SDE (under $1 million) and 3.1x ($1 million to $2 million) [3]. Each one sits within the BizBuySell range.

What moves the multiple in electrical work

Pushes it up Pushes it down
Maintenance contracts with stores, plants or property managers A few general contractors bring most of the work
A second licensed master who will stay The owner is the only master electrician
Signed backlog at healthy margins Thin backlog, or jobs bid at a loss to stay busy
Job costing that matches the books Profit that depends on how jobs were billed
Licensed journeymen with long tenure High turnover and no apprentices

Labor is the limit. The Bureau of Labor Statistics projects electrician jobs to grow 9% from 2025 to 2035, with about 72,700 openings a year [2]. A crew of licensed electricians who stay is worth real money to a buyer who would otherwise have to hire them. Show tenure, licenses and pay for each.

Buyers are active. Capstone Partners reported on October 9, 2026 that heating, plumbing and electrical made up 19.3% of home services deals so far that year [4]. That figure covers residential services, so it fits home service electricians more than commercial bid shops. More buyers can mean more offers. It does not change how one company is priced on SDE.

What electrical buyers ask to see

A buyer who likes your numbers will ask for proof. For an electrical contractor, expect requests for:

  • Three years of tax returns and financial statements, plus this year to date.
  • Revenue and margin split between service, maintenance contracts and bid work.
  • A backlog report: signed jobs not yet started or finished, with expected margin.
  • Work-in-progress reports that show how far along each open job is and how much is billed.
  • Customer list with revenue by general contractor and by maintenance account.
  • License records: the contractor license, the master of record and every electrician’s license.
  • Insurance certificates and your claims history.
  • Truck, lift and tool list with year, condition and loans.

Having these ready shortens the buyer’s close check of your books (diligence). See the full list of documents buyers ask for.

Half-done jobs at closing

Electrical sales have one detail that most trades do not: jobs in progress. At closing, you may have jobs that are half wired, half billed and half paid. Agree in the purchase agreement:

  • Who gets paid for work done before closing.
  • Who pays to finish each job, and what happens if it loses money.
  • Who keeps retainage that will be released later.
  • How warranty calls on past jobs are handled.

Most small sales are asset sales, where the buyer buys the trucks, tools, contracts and goodwill but not your company itself. Both sides then file IRS Form 8594 to report how the price is split [5]. The split affects your taxes. Read tax on selling a business.

Next steps

Sources

Every figure and link was checked on .

  1. Apply for a New Electrical Contractor License. Texas Department of Licensing and Regulation
  2. Occupational Outlook Handbook: Electricians. U.S. Bureau of Labor Statistics
  3. Market Pulse Q2 2026 Highlights (business value multiples by deal size). IBBA and M&A Source
  4. Residential Services M&A Update (October 9, 2026). Capstone Partners
  5. About Form 8594, Asset Acquisition Statement Under Section 1060. Internal Revenue Service
  6. Electrical & Mechanical Contractor Business Valuation Multiples & Financial Benchmarks. BizBuySell

Frequently asked questions

What multiple do electrical contractors sell for?

BizBuySell groups electrical and mechanical contractors together. In its records of those firms sold from 2021 to 2025, the middle half went for 1.96x to 3.15x SDE. A quarter sold below that and a quarter above. For all industries in Q2 2026, brokers reported 2.8x SDE on $500,000 to $1 million deals and 3.1x on $1 million to $2 million.

What happens if I am the master electrician on my company license?

In Texas, an electrical contractor must employ a licensed master electrician. When that person leaves, the company has 30 business days to name a new one. A master electrician can be assigned to only one contractor unless they own more than half of it. So if you are the master, the buyer needs a replacement lined up before closing.

Does my backlog add to the price?

Signed, profitable work that has not started helps a buyer trust your numbers. It usually supports the multiple rather than being paid for on top. Jobs that are half done are different. Buyer and seller must agree who gets paid for the finished part and who pays to finish the rest.

Is service work really worth more than new construction?

Usually. Service calls, panel upgrades and maintenance contracts repeat and are spread across many customers. Bid work for general contractors comes one job at a time, often from a few customers, with money held back until the end. Buyers pay more for each dollar of profit from repeat work.

More in Value your business · Glossary for owners · All guides